Luminous NXG 1100 Solar Inverter Price In india
Solar Hybrid UPS with inbuilt charge controllers are perfect choice for harnessing solar powers from panels to drive your household electrical loads. If you are looking for small inverter that can run you home load upto 600 watt then Luminous NXG 1100 best choice for you . You can connect upto 650 watt solar panel on it .You will need 1 battery for this inverter .In this inverter you will get PWM solar charge controller with 40Amp/12V rating.
The NXG Solar UPS can run on two modes – UPS and ECO mode. UPS mode should be selected when the user wants to run computers. In the UPS mode, the system switches to battery backup if the mains voltage drops below 180 V.If there are long power cuts in your area, you can use the i-charge fast charging mode for charging batteries in a short time when grid power is available. Note that when i-Charge is switched ON, Power saver mode is deactivated and the ups takes higher charging current from the grid. To activate this mode, use the i-charge ON/OFF switch at the back.
|Model Name||NXG 1100|
|Capacity (VA)||850 VA|
|Nominal Battery Voltage (Vdc)||12 V|
|Output Waveform||Sine Wave|
Solar Panel Input
|Charge Controller Type||PWM|
|Charge Controller Rating||40 A / 12V|
|Maximum PV Power||600 W|
|Input Voltage range (Voc)||19-25|
|Input Voltage range (Vmp)||17-19|
|Operating Voltage Range||100V – 290V|
|No Load Output||220±10V|
|Output frequency battery mode||50Hz±0.5Hz|
|No load current (UPS switch off)||< 65mA|
|UPS efficiency||≥ 80%*|
|Battery charging through Mains||Mains LED steady + Mains charge LED steady|
|Battery charging through Mains + Solar||Mains LED steady+Mains charge LED steady+solar CHG LED steady/Blinking|
|Battery charging through Solar||Solar CHG LED Blinking + Mains charge LED OFF|
|Low battery pre-alarm indication||Battery low LED blinking|
|Solar optimization after battery fully charged||ON mains+power save LED on+ON battery LED on+solar charge LED blinking|
|Over load||110% – 150% for 30 Sec. , 150%-180% for 10 Sec.|
|Short Circuit||200%- Short circuit|
|Overload shutdown indication in UPS mode||Overload LED steady|
|Overload pre-alarm indication in UPS mode||Overload LED slow blinking|
|Short circuit indication in UPS mode||Overload LED fast blinking|
|Protections||Short circuit, overload, high temperature, battery low cut off|
|Additional features||Switch on, Battery Charging;mains, solar, mains+solar; Overload, Short circuit, i-charge#|
|Switch on indication||Switch LED ON|
|UPS on indication||Battery LED ON|
|Internal fault||Service assistance LED on|
|Mains on indication||Mains LED steady|
|Mains charging current selection charge||10A (i-Chg OFF)/15A (i-Chg ON)|
|DC overload indication||(Mains LED+overload) blinking|
|Net weight (Kg)||11.5Kg|
|Gross weight (Kg)||12.7Kg|
|Dimensions LxWxH (mm)||375X315X135|
- Intelligent Solar Optimisation Technology – Maximises use of solar energy, charges from mains when required, saves 1.5-3 units per day.
- Pure sine wave UPS with 85% efficiency.
- Inbuilt charge controller for fast charging of batteries on solar.
- Battery type selector to configure charging currents as per connected battery.
Disclaimer: The Price & Specs Shown May Be Different From Actual. Please Confirm Before Purchasing.